Welcome, Guest. Please login or register.
Avoid-it « Recent Posts
Pages: [1]
 1 
 on: April 13, 2010, 11:31:13 AM 
Started by kate - Last post by kate
Generally known tips:
1. Don't keep them in the kitchen drawer - their blades shouldn't touch each other.
2. Don't put the knives in the Dishwasher - again the posibility of their blades coming into the contact with other hard objects and also corrosion caused by dishwasher detergents.
3. Don't use any GLASS cutting boards - they look modern and aesthetic but they are very hard. Also, try to avoid hard plastic boards. The best cutting boards are wooden ones.

All the above are most common mistakes people make in regards to proper using of the kithen knives.

However, I would like to point out one more mistake people very often make not even aware of the problem. The blocks are one of the options for a proper storage of the knives - either timber or steel or plastic. But even those proper storage blocks can dull cutting edges of the knives.
The worst are the blocks that hold the knives at an angle. As a result the knife rests on its cutting edge thus dulling it over a period of the time.
The best blocks are vertically oriented, in which the knife hangs straight down not wearing the cutting edge. Be carefull though, if not used properly they can dull cutting edges, too.

Most of us when placing the knife into the block's slot tend to lean the knife a little bit and rest its blade against the edge of the slot. Then slide the knife inside using the slot's edge as a guide. Each time the knife is inserted this way, it "cuts" the hard edge of the slot. Doing this repeatedly will dull the cutting edge of the knife as well.

There is a very simple solution for that; always put the knife "upside down" into the block, i.e. keep the kife with the cutting edge facing up and rest it on the slot's edge with its spine (the thicker top part of the blade). Then slide it down the slot. This way the cutting edge doesn't come into contact with hard eges of the the block and in the case of "angle blocks" the knife rests on its spine thus not wearing the cutting edge.

Please, see the picture below.  

 

 2 
 on: April 08, 2010, 10:05:14 AM 
Started by karol - Last post by tassie
Thanks for sharing; you,ve made 2 valuable points. That really sounds tricky: "yes you can order a black car, nevertheless give us 2 other colour options..."
By the way, how did you end up the whole issue?

 3 
 on: April 01, 2010, 09:16:58 PM 
Started by karol - Last post by karol
I went to a car dealer to buy my first brand new car. They didn't have the car with the options and colour I wanted, so it had to be ordered. I wanted black and the dealer said that's OK, but I still need to give them 3 options. I chose 1.Black 2.Dark grey 3.Light grey. Another thing I asked them was how long do I have to wait, because my car was to be ordered from Europe and transported to Australia. I was told about a month. Next week I got a phone call from the dealer saying that they've ordered one for me, guess which one - the light grey(my 3rd last option) and waiting is about 2 months. I couldn't understand it, if the car was ordered from the factory, why not black - my first option. The only reason I can think of is that the dealer pays less for certain colors. The other thing - waiting time, later at home I read the fine print which says the dealer is not responsible for any delays, and I can't complain about it. I wasn't happy about the colour and extra waiting but I was told by the dealer I've signed the contract therefore I can't walk out of it.
From the whole ordeal I've learned two things; firstly when you order a new car from any dealer don't give them any color choices, demand the one you like. Paying thousands of dollars you have the right to have what you want and not what the dealer wants to sell. The car is not a $20 dress you can wear once and throw it away. Secondly, demand the exact delivery time after which you are released from the contract, otherwise you may wait 6 months or longer and can't do anything about it.   Cool

 4 
 on: March 24, 2010, 07:47:23 PM 
Started by tassie - Last post by tassie
So, please remember that by clicking on the Agree button when you register to become a member of this forum, you agree to remain solely responsible for the content of your messages.
If you think you are anonymous on this forum, believe me you are not and if needed authorities will find you.

 5 
 on: March 24, 2010, 07:46:51 PM 
Started by tassie - Last post by tassie
You agree, through your use of this forum, that you will not post any material which is false, defamatory, inaccurate, abusive, vulgar, hateful, harassing, obscene, profane, sexually oriented, threatening, invasive of a person's privacy, adult material, or otherwise in violation of any International or Australian Federal law. You also agree not to post any copyrighted material unless you own the copyright or you have written consent from the owner of the copyrighted material. Spam, flooding, advertisements, chain letters, pyramid schemes, and solicitations are also forbidden on this forum.

Note that it is impossible for the staff or the owners of this forum to confirm the validity of posts. Please remember that we do not actively monitor the posted messages, and as such, are not responsible for the content contained within. We do not warrant the accuracy, completeness, or usefulness of any information presented. The posted messages express the views of the author, and not necessarily the views of this forum, its staff, its subsidiaries, or this forum's owner. Anyone who feels that a posted message is objectionable is encouraged to notify an administrator or moderator of this forum immediately. The staff and the owner of this forum reserve the right to remove objectionable content, within a reasonable time frame, if they determine that removal is necessary. This is a manual process, however, please realize that they may not be able to remove or edit particular messages immediately. This policy applies to member profile information as well.

You remain solely responsible for the content of your posted messages. Furthermore, you agree to indemnify and hold harmless the owners of this forum, any related websites to this forum, its staff, and its subsidiaries. The owners of this forum also reserve the right to reveal your identity (or any other related information collected on this service) in the event of a formal complaint or legal action arising from any situation caused by your use of this forum.
You have the ability, as you register, to choose your username. We advise that you keep the name appropriate. With this user account you are about to register, you agree to never give your password out to another person except an administrator, for your protection and for validity reasons. You also agree to NEVER use another person's account for any reason.  We also HIGHLY recommend you use a complex and unique password for your account, to prevent account theft.

After you register and login to this forum, you will be able to fill out a detailed profile. It is your responsibility to present clean and accurate information. Any information the forum owner or staff determines to be inaccurate or vulgar in nature will be removed, with or without prior notice. Appropriate sanctions may be applicable.

Please note that with each post, your IP address is recorded, in the event that you need to be banned from this forum or your ISP contacted. This will only happen in the event of a major violation of this agreement.

Also note that the software places a cookie, a text file containing bits of information (such as your username and password), in your browser's cache. This is ONLY used to keep you logged in/out. The software does not collect or send any other form of information to your computer.

 6 
 on: March 24, 2010, 07:46:15 PM 
Started by tassie - Last post by tassie
No liability is accepted by the owner or administrators or moderators of this forum
for advice offered by members posting replies or asking questions on any subject.
Especially we strongly advise contacting a Licensed Tradesperson for all plumbing and electrical work.
Information supplied within posts is not to be considered as detailed formal instructions to complete a task.
Members following such information do so at their own risk.


 7 
 on: March 24, 2010, 07:45:17 PM 
Started by tassie - Last post by tassie
This document is designed to clarify various responsibilities of community members here at this forum.

  1. Posts are to be made in the relevant forum.
  2. Members should post in a way that is respectful of other users.
  3. In your posts DO NOT DISCLOSE the details of third parties; including personal names, company names or addresses.
  4. Members should use an appropriate, descriptive TITLE when posting a new topic.
  5. Posting a nude, pornographic or generally offensive text, images, links, etc. will not be tolerated.
  6. Members are asked to respect the copyright of other users, sites, media, etc...
  7. Spam is not tolerated here under any circumstance. This includes offering deals on any goods or services, solicitation, recruiting members for your own projects, etc...
  8. No sex or pornographic related articles or links to websites promoting any of them.
  9. Users are permitted to use avatars of their own. User defined avatars are to be no larger than 100 pixels square, may not exceed 10kB.
10. Avatars are subject to the same conditions as posts with regard to decency, respectability, copyright, and so on...
11. Member should not act as moderators. If another member breaks rules, you may ignore that or report the problem to the moderators, but you may not use it as an excuse to break rules yourself.
12. The above rules also apply to private messaging. Abuse of the private messaging system will not be tolerated as well.

 8 
 on: March 24, 2010, 07:12:34 PM 
Started by tassie - Last post by tassie
Welcome to AVOID-IT discussion forum !

We hope you'll enjoy using our forum.  If you have any problems, please feel free to contact us by email to our support team.

Thanks!
Administrator

Pages: [1]